Hello,
I know this has been discussed on here before but Im desperate for help here. Total noob with pedal mods but very good with a soldering iron! Would really like to use this pedal on my board but cant cope with the tone sucking. can anyone give me a full retards guide to wiring in the bypass switch? I have the switch at the ready.
Big thanks in advance
Berhinger Vintage time machine true bypass mod
- phatt
- Transistor Tuner
A simple search found this,,,
https://www.freestompboxes.org/viewtopic ... 1&start=60
schematic on that page.
Without a close up of the inside I can't give you a blow by blow description of what to cut. Maybe post some pics
Cheers, Phil.
https://www.freestompboxes.org/viewtopic ... 1&start=60
schematic on that page.
Without a close up of the inside I can't give you a blow by blow description of what to cut. Maybe post some pics
Cheers, Phil.
- phatt
- Transistor Tuner
Assuming the schematic I mentioned is correct then here is a possible solution for true bypass,, but you will loose the LED indicator.
The red X's are wire cuts, but up to you to establish which wires are correct.
With a bit of thought you can probably use those existing wires to re route the signal, Also think about which ends to cut.
The Bypass position (Orange wire) can be done by just a short bridge wire across the terminals of the switch.
Hope it helps,, Phil.
The red X's are wire cuts, but up to you to establish which wires are correct.
With a bit of thought you can probably use those existing wires to re route the signal, Also think about which ends to cut.
The Bypass position (Orange wire) can be done by just a short bridge wire across the terminals of the switch.
Hope it helps,, Phil.