CheersKill Switch wrote:Props to the folks who spearheaded this project. Just built this and it worked on the first try. Very nice sounding phaser. Stayed true to the parts list, 4009, 4558 1.5 tant. Used 1% resistors throughout. I'm late to the party I know but then all the info already generated made it an easier build. The feedback pot has a subtle effect on the sound but it's noticeable. Sounds sublime in front of my echo base delay. I'm thinking of getting the LPB-1 worked out now and routing it in front of the phase as someone suggested a hotter signal improves it a bit. Sounds great as is though. Great project!
That's an interesting idea about the LPB-1... it does sound great with some grit in front of it! Suprisingly large amount of headroom for a CMOS based phaser.
It seems that a C/Rev Log taper should be used for rate incase anyone wonders, I used a linear and it is a tad bunched up, there was no information on this available at the time though (hence why the parts list doesn't state a taper to use) but B Tremblay did some experimenting for us and came to that conclusion.