Its that time that comes around once in a long time to change the cap cans in a vintage amp and do you guys have any sugestions or tips to do this right.I was thinking of cutting then with a dremmel and replacing the insides with radials and closing the can back up with epoxy. Thanks in advance
there is similar for more than U$30 a piece <but still not a direct replacement and you need a huge soldering iron to remove the blobs of solder from the chassie,I could dremel the solder but makes a mess inside the amp,not recommended by people who have done it. Aharon
you can go a little higher in uf but probably not lower in voltage for a replacement, i've done some multi filter caps where I cut the leads off close to the can so the connections stay correct and pull the can out and plop a new one in and solder to the old terminals , hope that helps or is possible in your case!