Tube or solid-state, this section goes to eleven!
I need help with were i put the in and out signal for this one tube reverb on a peavey windsor head.
You do not have the required permissions to view the files attached to this post.
- Posts: 24
- Joined: 17 Nov 2013, 02:09
- Has thanked: 4 times
- Have thanks: 0 time
I'd try inserting after *C13* which is the output of the preamp section. (post FX loop)
You will need to insert a series resistor,, same as the 100k on the Carolina schematic.
You will likely have to raise the value of the series resistor to get a convincing reverb.
There will likely be some signal loss but as the circuit has plenty of gain it may not be a problem.
- Diode Debunker
- Posts: 896
- Joined: 04 Aug 2010, 06:17
- Location: Bairnsdale ,Victoria, Australia
- Has thanked: 0 time
- Have thanks: 222 times
Return to Amplifiers
Who is online
Users browsing this forum: bool, storyboardist and 5 guests