need help adding reverb to peavey windsor head

Tube or solid-state, this section goes to eleven!

need help adding reverb to peavey windsor head

Postby Jayallen » 27 Dec 2016, 03:36

I need help with were i put the in and out signal for this one tube reverb on a peavey windsor head.
CBS.GIF
CBS.GIF
.
You do not have the required permissions to view the files attached to this post.
Jayallen
 
Posts: 24
Joined: 17 Nov 2013, 02:09
Has thanked: 4 times
Have thanks: 0 time

Re: need help adding reverb to peavey windsor head

Postby phatt » 28 Dec 2016, 09:03

I'd try inserting after *C13* which is the output of the preamp section. (post FX loop)
You will need to insert a series resistor,, same as the 100k on the Carolina schematic.
You will likely have to raise the value of the series resistor to get a convincing reverb.
There will likely be some signal loss but as the circuit has plenty of gain it may not be a problem.
Phil.
phatt
Diode Debunker
 
Posts: 949
Joined: 04 Aug 2010, 06:17
Location: Morayfield SE Qld AU
Has thanked: 0 time
Have thanks: 232 times


Return to Amplifiers

Who is online

Users browsing this forum: No registered users and 5 guests