HELP - Eagle

BennyBoop · Post by **BennyBoop** » 27 Jan 2009, 17:32

I drew a schematic and was satisfied with the result. I'm new to eagle and don't know all about it, so I deleted the parts names instead of just turning off that layer of view. If I use the name tool and click on a part I will get the name in that window, but is there a way to se the parts names in the schematic?

Thanks/Ben

marshmellow · Post by **marshmellow** » 28 Jan 2009, 11:18

Did you SMASH those parts before? That would be the only way I know of to delete the names. Then you just have to unsmash them. Use SMASH + Shift and click on the part or uncheck "smashed" in the properties dialog.

BennyBoop · Post by **BennyBoop** » 28 Jan 2009, 22:22

Okay, thanks.

Yeah, I did smash them to place all the names and values where I wanted them. Needed it to be done yesterday though so I had to redraw it. But good to now for the future!