Parallel Box
Posted: 14 Oct 2017, 21:03
Hi
I would like to build a simple passive box which would allow me to run two signal paths in parallel :
- One dry (with a volume control),
- and one going to an external effect loop (with pre and post volume control).
I have been using a passive mixer schematic i had found a couple years ago on the web (i think it was from Beavis audio website, but i can't find it anymore), and tried to modify it to suit my needs.
Overall, it's a very easy project, but I am rather new to DIY, so i am not sure my schematic is good.
Could anyone give it a look and tell me if it is allright ?
Mainly, I am not sure if the black wires (negative/ground) are all connected as it should.
Thank you in advance for any advice.
I would like to build a simple passive box which would allow me to run two signal paths in parallel :
- One dry (with a volume control),
- and one going to an external effect loop (with pre and post volume control).
I have been using a passive mixer schematic i had found a couple years ago on the web (i think it was from Beavis audio website, but i can't find it anymore), and tried to modify it to suit my needs.
Overall, it's a very easy project, but I am rather new to DIY, so i am not sure my schematic is good.
Could anyone give it a look and tell me if it is allright ?
Mainly, I am not sure if the black wires (negative/ground) are all connected as it should.
Thank you in advance for any advice.