Can I apply BSIAB2 mods to this "BE-OD" clone layout?
Posted: 24 Feb 2018, 19:36
I have built several BSIABII's and tweeked and played with many mods. One mod I liked on some of my BSIAB's was having the cap parallel with the 5.6k resistor off of Q5 to add some nice high end crunch and crispness. I was wondering where in this BE-OD clone circuit I could do the same thing? I am not sure it is even possible as I am still mostly a "paint -by-numbers" guy and so don't fully understand how a circuit flows.
Is it possible to adapt this mod that I liked on the BSIAB II http://www.generalguitargadgets.com/pdf ... ab2_sc.pdf to my pedalpcb.com "BE-OD" http://www.pedalpcb.com/docs/ThermionicDistortion.pdf build? If so, where in the layout would I place?
Is it possible to adapt this mod that I liked on the BSIAB II http://www.generalguitargadgets.com/pdf ... ab2_sc.pdf to my pedalpcb.com "BE-OD" http://www.pedalpcb.com/docs/ThermionicDistortion.pdf build? If so, where in the layout would I place?