Have You Ever Seen This Wiring/Pickup Negative to Capacitor

Pickups, wiring schemes, switch techniques and onboard active electronics for guitars and basses
Post Reply
User avatar
Rocket Roll
Solder Soldier
Information
Posts: 249
Joined: 27 Mar 2008, 08:25
Location: Belgrade
Has thanked: 19 times
Been thanked: 44 times
Contact:

Post by Rocket Roll »

This is a seventies' Strat which should be all stock (though the pickups do seem a bit strange to my unexperienced eye... non-staggered polepieces). But look at this pickup configuration mass / negative pole - all three pickups are going to a 330nF capacitor, and then to ground. The rest of the wiring, upon a brief survey, appears stock.

It should not even work, maybe. But the owner (a great guitar player) swears by it - more sustain and a sort of compression unobtainable in any other way, says he.

What say you? Have you ever seen that kind of wiring?
20171030_172626.jpg
20171030_172816.jpg

User avatar
Rocket Roll
Solder Soldier
Information
Posts: 249
Joined: 27 Mar 2008, 08:25
Location: Belgrade
Has thanked: 19 times
Been thanked: 44 times
Contact:

Post by Rocket Roll »

Update - it does seem it's a part of the circuit described here: http://www.singlecoil.com/docs/shielding_strat.pdf

User avatar
Cub
Cap Cooler
Information
Posts: 458
Joined: 29 Aug 2011, 07:14
Location: The Netherlands
Has thanked: 102 times
Been thanked: 118 times

Post by Cub »

I believe non-staggered magnets became standard somewhere in the second half of the '70s, so that's probably alright then.

A high voltage cap of about .22µF to .47µF is often used to protect you from being zapped by a tube amp that's not working properly. However, one end of the cap is then the star-ground while the other end goes to the sleeve of the jack.

edit: Ah, you posted about that while I was typing. Good show.
I wish I were a chestnut tree, nourished by the sun.
With twigs and leaves and branches and conkers by the ton.

User avatar
phatt
Transistor Tuner
Information
Posts: 1224
Joined: 04 Aug 2010, 05:17
Location: Morayfield SE Qld AU
Has thanked: 8 times
Been thanked: 343 times

Post by phatt »

Hard to tell but it looks like it's ONLY the PU ground wires are isolated from circuit common.
While the link lifts the whole circuit off circuit Common,,,so they are different ,, I think?
too late now, bedtime here I'll look tomorrow.
Phil.

User avatar
John Mackenzie
Information
Posts: 9
Joined: 05 Dec 2017, 14:06

Post by John Mackenzie »

Is this not an attempt to make a "treble bleed" circuit on the volume control? The ones I have seen also have a resistor in parallel with the cap. I can't tell from he pics.

User avatar
John Mackenzie
Information
Posts: 9
Joined: 05 Dec 2017, 14:06

Post by John Mackenzie »

John Mackenzie wrote:Is this not an attempt to make a "treble bleed" circuit on the volume control? The ones I have seen also have a resistor in parallel with the cap. I can't tell from he pics.

Having looked at this a bit further, I am convinced that I an wrong with my suggestion as above. i think it is a safety feature, as a previous member suggested. The article he posted the link to is very good, and explains everything.

Post Reply