very simple sine wave generator

Frequently asked questions about tools and instruments used in stompbox development.

very simple sine wave generator

Postby mozwell » 14 Feb 2011, 00:23

This was redrawn from an Australian electronics magazine...
I use this to test with.

Very simple sine wave genarator. The trick in this one, is that harmonic cancellation is used to get a very low distortion sine wave. Output amplitude stability is also very good.

I hope this is of use to others.
You do not have the required permissions to view the files attached to this post.

For this message the author mozwell has received thanks: 2
dongyufeng (02 Aug 2011, 10:22), rocklander (01 Apr 2014, 01:37)
Breadboard Brother
Posts: 112
Joined: 12 Mar 2009, 00:01
Location: Melbourne, Australia
Has thanked: 22 times
Have thanks: 69 times

Re: very simple sine wave generator

Postby JOHNO » 21 May 2013, 11:15

Here is another schematic also from Electronics Australia magazine. This one is has a sweep-able frequency of some where around 735Hz to 18kHz. The distortion is only 0.16%. Output is 1.27Vrms.
EA oscillator.png
User avatar
Cap Cooler
Posts: 599
Joined: 21 Jun 2009, 08:13
Has thanked: 52 times
Have thanks: 62 times

Re: very simple sine wave generator

Postby DrNomis » 23 May 2013, 04:42

Nice design, should be fine for general troubleshooting work, most of the time you can just get by with a sinewave generator that doesn't have low-distortion, this should be on everyone's "To Build" list..... :thumbsup
Genius is not all about 99% perspiration, and 1% inspiration - sometimes the solution is staring you right in the face.-Frequencycentral.
User avatar
Old Solderhand
Posts: 6899
Joined: 16 Jul 2009, 05:56
Location: Darwin,Northern Territory Australia
Has thanked: 123 times
Have thanks: 402 times

Re: very simple sine wave generator

Postby ivan H » 26 Nov 2014, 23:21

Hi, a search for a sine wave generator led me to this thread. The generator looks ideal for my needs, & simple enough to build on vero board, however I do have one query. On the left of the schematic are 4 caps (switchable) that are designated 1u, 0.1u, 0.01u & 0.001u, however to the left of these is marked 0.22u, 0.022u, 0.002u & 220p. Does anyone know wot gives here? Simple enough to try both lots of values, I am just hoping that there is someone who has built this that could clarify.
Thank in advance. Cheers
ivan H
Breadboard Brother
Posts: 64
Joined: 29 Sep 2012, 06:21
Has thanked: 0 time
Have thanks: 9 times

Return to Electronics Tools

Who is online

Users browsing this forum: No registered users and 1 guest