ISP Decimator G string  [traced]

General documentation, gut shot, schematic links, ongoing circuit tracing, deep thoughts ... all about boutique stompboxes.
Post Reply
User avatar
POTL
Resistor Ronker
Information
Posts: 335
Joined: 26 Sep 2016, 03:11
Has thanked: 58 times
Been thanked: 67 times

Post by POTL »

This is vero schematic :D
I have 2 questions
1) DA 1.1 Whether it is an obligatory part of the circuit or just closes the second half of the chip
2) DA 2.2 The voltage divider is perfectly capable of operating without a chip, why is it here?
P.S.
JFET КП303А, D7,C12,R34,R42,LED,D11 Must be removed if you want true bypass.
Attachments
ispdecimator.jpg

User avatar
alexradium
Resistor Ronker
Information
Posts: 313
Joined: 31 Jan 2010, 13:31
Has thanked: 64 times
Been thanked: 68 times

Post by alexradium »

these are normal textbook practices,just read one and you get it.

User avatar
bmxguitarsbmx
Cap Cooler
Information
Posts: 510
Joined: 25 Mar 2010, 21:15
Has thanked: 704 times
Been thanked: 216 times

Post by bmxguitarsbmx »

You could probably get away without the DA 1.1 buffer.

I wouldn't advise simply using a resistive voltage divider + capacitor to establish a bias voltage for this circuit as the circuitry draws current asymmetrically from the supply. This asymmetrical current draw will work against the long time constant of the bias supply to cause bias voltage shifts that may cause clipping and unpredictable results. The often seen resistive voltage divider + cap bias supply is really only a low impedance to A.C. signals. Any D.C. offset, transient signal, or even circuitry with asymmetrical clipping/distortion can cause problems with the very common voltage divider + cap buffer.

Hope that is helpful/ makes sense. :)

User avatar
POTL
Resistor Ronker
Information
Posts: 335
Joined: 26 Sep 2016, 03:11
Has thanked: 58 times
Been thanked: 67 times

Post by POTL »

Already with all understood.
Now I'm confronted with another question, can I replace LF353 with TL072 or TL082.
Or is the circuit designed for LF353?

User avatar
PLUT0music
Information
Posts: 2
Joined: 11 Sep 2018, 07:12

Post by PLUT0music »

Is this schematic verified? Did someone build and test it yet?
Would like to have one, but don't want to start the project if it is faulty.

Post Reply