pedalgrinder wrote:How did you go mullisman you were going to post your latest eagle files. Iam pretty keen on them since they have the boost section and i see that as a majority of the point of this pedal. To do one without the boost makes it no different to a glorified tubescreamer in my view. The boost is what sends it into overdrive mayhem.
Sorry for the long wait. I've been busy getting married and working. Here are the eagle files for the disortion section and the boost section of the Triple Wreck.
Only differences here are the power section. The power for the Boost board comes from the distortion board, there's a pad labeled Va, use that.
Cheers.
JM
Hi guys! Anyone used this pcb? Work?
No but, the madbean "upper decker" layout is excellent!! Works 100% and has on-board pots and the boost circuit!
Don't know if it's posted here but I can send it to you if you can't find it..
I also redrew the layout with the pots all mounted facing the same way... The parts layout is pretty much the same but had to move around a few components to make it work... You will have to figure that out for yourself if you want to use my redrawn layout, not that hard to figure out!
I think I have seen that one before...? I like the use of the TL074 and no boost circuit! The boost is awful in my opinion and doesn't need any boost either.. Plenty of gain without it. The boost just makes it into a fuzz box, kills the attack and just sounds like garbage...
"The N has better heat dissipation and is good at higher temperatures than the cheaper P package"
This is a quote I found some where on the internet.
Both will do just fine.
TL072 is the actual op-amp chip and manufacturers may add suffixes to denote the type of package and or operating temperature. In this case the 'P' means it's in a plastic DIP (Dual Inline Package) but other manufacturers may use 'N' to mean the same thing etc... I don't think operating temperature will factor in much in this case.
im looking at rcustoms layout then i see x1 x2 x3. I will make a two hole for input, output, and volt? how can i wire that into the 3dpt? or can someone send me the schematic and pcb layout of madbeans?
leftfingaz wrote:im looking at rcustoms layout then i see x1 x2 x3. I will make a two hole for input, output, and volt? how can i wire that into the 3dpt? or can someone send me the schematic and pcb layout of madbeans?
just see the schematics remember this is only the main circuit not include the boost section
leftfingaz wrote:im looking at rcustoms layout then i see x1 x2 x3. I will make a two hole for input, output, and volt? how can i wire that into the 3dpt? or can someone send me the schematic and pcb layout of madbeans?
just see the schematics remember this is only the main circuit not include the boost section
Completed builds: rebote 2.5; supreaux; odie; heartthrob tremolo; ross phaser; dr. boogey; thor; baja black toast; slow gear attack, rebote, tri-vibe, small clone, little angel, magnus modulus, echo base, hex fuzz, big muff, 22/7.