Page 3 of 3

Re: Castledine Electronics - The Wizard

PostPosted: 07 Apr 2018, 15:22
by Manfred
Schematic and layouts, the capacitor values should be correct now.
WizCorrectedSchematic.JPG

WizCorrectedLayout.JPG

WizSprintLayoutFile.zip

I cerated a Vero-layout, but it is not applied yet and not verfied until now.
The lot of wire jumper results from the trial to keep the layout small.
WizVeroLayout.jpg

WizLochMasterFile.zip

WizVeroComponetSide.pdf

WizVeroBothSides.pdf

The solder side is folded downwards shown.
WizVeroSolderSide.pdf

WizVeroSolderSideOriginalSize.pdf

Re: Castledine Electronics - The Wizard  [traced]

PostPosted: 09 Apr 2018, 00:13
by Manfred
A re-examination gave some other resistor values as follows:
R4 old 22k -> new 10k
R5 old 4k7 -> new 3k9
R18 old 22k -> new 10k
R19 old 22k -> new 10k
R20 = 22R added.

WizCorrectedSchematic2.JPG

WizCorrectedLayout.JPG

WizSprintLayout6_FileCorrected.zip

WizPCBSolderSide.pdf

WizPCBSolderSideMirrored.pdf

WizVeroLayoutCorrected.jpg

WizVeroBothSidesCorrected.pdf

The solder side is folded downwards shown.
WizVeroSolderSideCorrected.pdf

WizVeroSolderSideCorrectedOriginalSize.pdf

Re: Castledine Electronics - The Wizard

PostPosted: 09 Apr 2018, 22:42
by Intripped
hey! :D
..may i ask where did you take these new values from?
have you got the real pedal on your bench?

i can see that the old values of the resistors are coherent with the pics in the previous page, so ...are there 2 versions of this circuit?
would be interesting to determine which is the most recent

thanks again for your work!

Re: Castledine Electronics - The Wizard

PostPosted: 09 Apr 2018, 23:03
by Manfred
Intripped wrote:hey! :D
..may i ask where did you take these new values from?
have you got the real pedal on your bench?

i can see that the old values of the resistors are coherent with the pics in the previous page, so ...are there 2 versions of this circuit?
would be interesting to determine which is the most recent

thanks again for your work!


No, I have not got the pedal on the bench, I got the information form another source.
I do not know which is the most recent, I guess the second one.
But anyway-the second one is verified.

Re: Castledine Electronics - The Wizard

PostPosted: 07 Mar 2019, 08:49
by Blues1911
Manfred wrote:No, I have not got the pedal on the bench, I got the information form another source.
I do not know which is the most recent, I guess the second one.
But anyway-the second one is verified.


Manfred, please notice that C2 value is reported right on the PCB (47uf) but not on the schematic, where is still wrongly noted as 100uf.

Re: Castledine Electronics - The Wizard

PostPosted: 07 Mar 2019, 09:08
by Manfred
Hi Blues 1911,

thanks for the hint.
Here the corrected Schematic:
WizCorrectedSchematic3.JPG