bumpsevinisthenumber wrote:Were do i place the pre gain knob into the circuit? Use a 100ka pot on the input as a variable resistor?
Keeley Compressor C4 [gut shot] [traced]
- gkoerselman
- Breadboard Brother
I assume that with the 'pre gain' you actually mean the 'clip' control (which is sometimes called 'clipping' or 'trim' I believe on the actual enclosures)...
This clip control is the 150k shown in my diagram connected by pad P1A-B and P2A-B.
This clip control is the 150k shown in my diagram connected by pad P1A-B and P2A-B.
- irmcdermott
- Breadboard Brother
So the trimmers are still in there? As well as the external pots? I'm just a little confused reading through the thread.
- bubstance
- Solder Soldier
Information
It's a Ross clone, so any Ross layout/schematic will do just fine. Also: viewtopic.php?f=7&t=4860#p64200.
powered by 9front
- WhiteKeyHole
- Cap Cooler
So buy one and be sure to tell us your findings.
- bubstance
- Solder Soldier
Information
Don't trust hype. Remember the hype about the CJOD? Turns out that wasn't very different. Remember the Saffron Squeeze? That was a Ross too.seedseed wrote:Yeah but for all the hype i've heard about this pedal it can't be exactly the same with all components there has to be some form of variation. I'd like to know what it is.
Hype =/= different.
powered by 9front
When that resistor is set to 10K I can hear only a little bit more volume but I can't see differences in the attack of the compression....
Can you explain to me which differences I should hear from a 150K to a 10K?
Which sound test can I make (playing the guitar) to hear better this difference?
Can you explain to me which differences I should hear from a 150K to a 10K?
Which sound test can I make (playing the guitar) to hear better this difference?
- WhiteKeyHole
- Cap Cooler
seedseed wrote:Yeah no worries whitekeyhole with your money hahhaha
- The Rotagilla
- Diode Debunker
Yes.Crimson wrote:Sustain pot: are you sure is reverse log?
The television will not be revolutionized.
- IvIark
- Tube Twister
Information
Currently unverified but I'll let you know when that changes. Instead of using two 1K resistors I left the trimmer used in the Dyna Comp and Ross Comp in place, so if you leave it in its middle setting that would replicate the C4 with the added advantage of being able to fine tune the extremes of the Clip control.
"If anyone is a 'genius' for putting jacks in such a pedal in the only spot where they could physically fit, then I assume I too am a genius for correctly inserting my legs into my pants this morning." - candletears7 - TGP
- IvIark
- Tube Twister
Information
The vero has been verified so it's safe to build
"If anyone is a 'genius' for putting jacks in such a pedal in the only spot where they could physically fit, then I assume I too am a genius for correctly inserting my legs into my pants this morning." - candletears7 - TGP
- pedalgrinder
- Cap Cooler
great vero and thanks for the contribution but it's still not a verified keeley we still have no idea what's in and before someone says there fav comment of go buy it. We should do a tracers fund and contribute $10 bucks each so we all put in. I'll put in $10 anyone else up for it.
What's the best thing about fat chicks and scooters? There both fun to ride around until your mates find out!
- IvIark
- Tube Twister
Information
If we bought one via the tracers fund we'd end up with exactly the same gut shot as you already have on page 1 of this thread. So this is no more and no less verified than any other pic > trace > schematic > layout on the site. In fact the quality of the gut shot with trace and BOM by vietpham, this is likely to be more accurate than some of our other traces.
"If anyone is a 'genius' for putting jacks in such a pedal in the only spot where they could physically fit, then I assume I too am a genius for correctly inserting my legs into my pants this morning." - candletears7 - TGP
- IvIark
- Tube Twister
Information
Just as a follow up to that, here's the gutshot with the missing resistor values:
Looks pretty accurate to me so I'm not too sure what else we could be missing.
Looks pretty accurate to me so I'm not too sure what else we could be missing.
"If anyone is a 'genius' for putting jacks in such a pedal in the only spot where they could physically fit, then I assume I too am a genius for correctly inserting my legs into my pants this morning." - candletears7 - TGP