jymaze wrote:Jim, can you verify the 2nd resistor down from the tone pot (read 3k3 right now). I labeled it 332 on my draft, but I see you only put a question mark there (by the tone pot).
My way of superposing the layers: I just put the 2 sides in GIMP as 2 layers, aligned them the best I could, and was switching from one to the other for 12 million times. I know that PCB like the back of my hand now! Even with both sides aligned it was not an easy trace because of the density and the constant random jumping from one layer to the other.
If we could make sure the values for the resistors are good on the pictures, I can correct on my draft schematic. There are one or 2 I really wonder about.
If you are referring to the schematic I posted that was from euronymous0001's Eagle file that I imported so people could read it... not mine, and I saw quite a few unidentified components on it as well.
this is correct and I made sure with a meter.
https://www.freestompboxes.org/download/ ... &mode=view
When they are marked like 3k32 you can take that as 3.3k or 3.32k, 47k5 = 47k or 47.5k etc...
By the way - That large 1W light blue "resistor" in the bottom left reads 47 ohm exactly.
Still unsure about the gate/gain pot... one lug is not connected to anything for the gate like the gate on the BF or Engl I made.../ jsx noise gate etc..
Also, from looking at the actual board, to me it looks like the gate has 3 diodes (two 1N4148 and one 1N4733) and a 220n cap or, am I seeing things?