PCB Veroboard

[fishfude]

Hi Folks,

Bear with me here: I have an idea for a PCB that would be very hackable, with vias everywhere and let's say sockets. At some point I imagine I might want to break traces and/or jumper them later. Is there a way I could create on a PCB, a point where using a veroboard trace cutter, I could simply make a cut and break the trace?

Thanks,

ff

[Pyr0]

drill 3 small holes in the track (with pads) where you might want a cut, then just use a vero cutter or drill to cut at the middle hole, if you want to bridge it again, add a jumper between the outer holes.