need help adding reverb to peavey windsor head

Tube or solid-state, this section goes to eleven!
Post Reply
User avatar
Jayallen
Information
Posts: 24
Joined: 17 Nov 2013, 01:09
Has thanked: 3 times

Post by Jayallen »

I need help with were i put the in and out signal for this one tube reverb on a peavey windsor head.
CBS.GIF
CBS.GIF
.
Attachments
power.png
Untitled.png

User avatar
phatt
Transistor Tuner
Information
Posts: 1224
Joined: 04 Aug 2010, 05:17
Location: Morayfield SE Qld AU
Has thanked: 8 times
Been thanked: 343 times

Post by phatt »

I'd try inserting after *C13* which is the output of the preamp section. (post FX loop)
You will need to insert a series resistor,, same as the 100k on the Carolina schematic.
You will likely have to raise the value of the series resistor to get a convincing reverb.
There will likely be some signal loss but as the circuit has plenty of gain it may not be a problem.
Phil.

Post Reply