Alexander Pedals - Equilibrium

General documentation, gut shot, schematic links, ongoing circuit tracing, deep thoughts ... all about boutique stompboxes.
Post Reply
User avatar
jtn191
Solder Soldier
Information
Posts: 162
Joined: 01 Jan 2011, 10:28
Has thanked: 31 times
Been thanked: 22 times

Post by jtn191 »

Fav new trem/modulation pedal...
Attachments
tremsemiconductor.jpg
tremsemiconductor.jpg (61.83 KiB) Viewed 1155 times
trem.jpg

User avatar
plush
Cap Cooler
Information
Posts: 639
Joined: 08 Dec 2015, 09:29
Location: Moscow, Evil Russia
Has thanked: 36 times
Been thanked: 169 times

Post by plush »

Hi!

There is no point of sharing another typical FV-1 layout, with a scent of boutiqueness and rosin, without grabbing the firmware - 24LC chip is asking for it, it's not even soldered :D

User avatar
Ice-9
Degoop Doctor
Information
Posts: 1094
Joined: 31 Mar 2009, 15:29
my favorite amplifier: Marshall
Completed builds: Far to many to afford the enclosures for them all. :)
Has thanked: 134 times
Been thanked: 359 times
Contact:

Post by Ice-9 »

there is an ugly amount of un-cleaned flux all over the PCB . :hmmm:
It's fairly straight forward, if you want to start it , press start. You can work out the rest of the controls for yourself !

No silicon heaven ? preposterous ! Where would all the calculators go ?

User avatar
jtn191
Solder Soldier
Information
Posts: 162
Joined: 01 Jan 2011, 10:28
Has thanked: 31 times
Been thanked: 22 times

Post by jtn191 »

plush wrote:Hi!

There is no point of sharing another typical FV-1 layout, with a scent of boutiqueness and rosin, without grabbing the firmware - 24LC chip is asking for it, it's not even soldered :D
well if someone wanted to see inside, there ya go! ;)

User avatar
plush
Cap Cooler
Information
Posts: 639
Joined: 08 Dec 2015, 09:29
Location: Moscow, Evil Russia
Has thanked: 36 times
Been thanked: 169 times

Post by plush »

jtn191 wrote:
plush wrote:Hi!

There is no point of sharing another typical FV-1 layout, with a scent of boutiqueness and rosin, without grabbing the firmware - 24LC chip is asking for it, it's not even soldered :D
well if someone wanted to see inside, there ya go! ;)

Hey man, I'm sorry for being a jerk :(
I occasionally forget that working with dsp can be a bit complicated and require some additional tools and knowledge.
Thanks for sharing.

Post Reply