Keeley - 30ms Double Tracker
- floris
- Cap Cooler
Keeley 30ms Double Tracker gutshots.
Spin Semiconductor FV-1 for audio delay / detune / reverb: http://www.spinsemi.com/products.html
24LC32A 8pin DIP EEPROM that holds the program for the FV-1 chip.
TL074 for the audio path, probably buffers and such to interface with the FV-1 chip.
TQ2-9V "single side stable" DPDT relay that is used for true bypass next to a 3PDT foot-switch.
4x 10kB pots for controlling the parameters of the program running on the FV-1 chip.
Spin Semiconductor FV-1 for audio delay / detune / reverb: http://www.spinsemi.com/products.html
24LC32A 8pin DIP EEPROM that holds the program for the FV-1 chip.
TL074 for the audio path, probably buffers and such to interface with the FV-1 chip.
TQ2-9V "single side stable" DPDT relay that is used for true bypass next to a 3PDT foot-switch.
4x 10kB pots for controlling the parameters of the program running on the FV-1 chip.
- caspercody
- Resistor Ronker
Check out Pedalpcb.com Unison Double tracker. Might help with the schematic.
http://www.pedalpcb.com/product/unison/
http://www.pedalpcb.com/product/unison/
- floris
- Cap Cooler
Yes I also found that interesting. Seems overkill.Boba7 wrote:A relay AND a 3pdt?
Also the PCB mentions a "trails" function next to the 2 DIP switches and at the bottom of the PCB.
But this is not implemented as far as I can see.
- floris
- Cap Cooler
Some picts with IC1 TL074 quad opamp removed:
Opamp B has minus input and output connected together so it is a buffer.
Opamp C has a resistor between input and output and works as an amplifier or mixer.
Opamp D is not used.
In my pedal, the signal was very soft.
Measurements on the IC1 TL074 pins showed that the opamps were not working properly: Output pins were not at V-bias of 4,5V DC.
I replaced IC1 with a new TL074, and all is working again.
Opamp B has minus input and output connected together so it is a buffer.
Opamp C has a resistor between input and output and works as an amplifier or mixer.
Opamp D is not used.
In my pedal, the signal was very soft.
Measurements on the IC1 TL074 pins showed that the opamps were not working properly: Output pins were not at V-bias of 4,5V DC.
I replaced IC1 with a new TL074, and all is working again.