[Tips & Tricks] Perfboard Building
- drmathprog
- Breadboard Brother
Information
- Posts: 67
- Joined: 02 Jan 2008, 23:16
I'm inspired by the Eternity and King of Tone perfboard projects. Can someone point me to a tutorial or suggest techniques for soldering a perfboard project? Specifically, I'm not clear on how I can solder the components on one side to the wires on the other side.
- ieatyouforbreakfast
- Breadboard Brother
don't cut the leads to the components and use the extra lengths as traces.
- drmathprog
- Breadboard Brother
Information
- Posts: 67
- Joined: 02 Jan 2008, 23:16
Thanks. Seems obvious, but it didn't occur to me until I read your post.
Information
- Posts: 23
- Joined: 03 Jan 2008, 15:16
- Location: Los Angeles
- drmathprog
- Breadboard Brother
Information
- Posts: 67
- Joined: 02 Jan 2008, 23:16
That's perfect; I don't know why I couldn't find it! Thanks!
The Tweak-O project has hole-by hole instructions, and shows both sides of the board at several stages. It was my first build, and I was very fortunate to have this project as a guide.
-Alex
-Alex
- drmathprog
- Breadboard Brother
Information
- Posts: 67
- Joined: 02 Jan 2008, 23:16
Thanks Alex. I've never seen those push in terminal posts before. Where did you find those?